It wasn´t necessary to modify the status again. Anyway please also use CAR 1 after modifying the status to PT, UT or ST like requested in the attached mail and the related work instruction. All red dates in the picture below will be green if you follow this request.When you get a message about a deviation from CAR1-check (see red circle in the picture above) please give me some information about it in the E-Mail. In this case I found out it is just a missing “where used”-check and in this case the check was nonsense because you created the component. I will check if we can avoid this message for this situation in future. But for future it is important to check if components are used by other colleagues by the engineering tool “where used” and if the modifications are ok for the displayed colleagues.